8 Ohm Klipsch Samsung Bookshelf or Tower Kit Dual 5.25" Woofers 150 Watts RMS

Yes, it OK to Bust a button when your friend says, “BOY THAT SPEAKER SOUNDS GREAT, WHERE DID YOU GET IT?”

You respond, “I BUILT IT MYSELF.” Just watch their jaw drop, and their impression of you go up.

Remember, this is not some meak speaker kit here, you get 2 solid fully shielded 5 1/4″ Klipsch Foster woofers for excellent quality lows, and a Samsung High Output tweeter for crisp clean highs.

Surprise yourself and dazzle your friends with this Do it yourself ( DIY ) project.

What do you get:
• Four 5 1/4 inch Shielded Foster Cloth Surround Woofers 50 Hz to 7500 Hz. 75 watts, 16 ohms, 1″ vc
• Two Samsung High Output Dome Tweeter 95 db, dome, 10 oz, 2.5kHz to 20 kHz, 8 ohms
• Two Cerwin Vega 2 way Crossover, 150 watts, cross-over point 3400 Hz, 12 db..
  note that the woofers need to be wired in parallel to get an 8 ohm impedence, doing so also doubles the power capability.

  Performance:

• Power: 150 Watts RMS
• SPL: 92 db or greater
• Response: 45 Hz to 20000 Hz.
• Imp.: 8 ohms nominal

Cabinet Requirements:

Perfect for any cabinet with a volume of about .5 to .75 cf

If you built cabinets with inside dimensions of 13 inches by 7 inches by 7 inches, & if you use 3/4 inch MDF your outside dimensions would be 14.5 inches by 8.5 inches by 8.5 inches, but build to suit you needs, just keep the internal volume to about the .4 to .75 cf model and you’ll do fine.
*Note that a good material for this project is MDF, you can buy a nice piece of MDF shelving at your local building supply house for about $3.00 in 8 foot lengths (one 8 foot length should be plenty for this box), most have a nice rounded nose for a stylish look. So for about $35.00 you can build one heck of a nice sounding and performing speaker.

Now for those who need a bit of help in wiring the woofers in parallel. you will need two lenghts of wire (12 to 18 inches). Take the red leads from the crossover, and connect them to woofer number one, (lead with stripe is negative) then take the two lenghts of wire that you have and connect to the two woofers, positive to positive, and negative to negative. That’s it, they are parallel.

*A note to the builder, this kit can be used for either a Center Channel or Book shelf style of speaker you just mount the speakers in a different configuration, the boxes are the same size.
See the Layout Pictures…

Layouts that I have used, but you can be as creative as you choose…